1998 Nissan Sentra TIMING CHAIN Removal
download CAUTION: If camshaft or crankshaft is rotated with timing chain disconnected, piston will contact valves, resulting in bent valves. NOTE: For reassembly reference, apply paint marks to timing...
View Article1997 Ford F-250/350/Super Duty Engine Front Cover Removal
download Crankshaft front seal replacement is recommended whenever the engine front cover (6019) has been removed. 1. Disconnect battery ground cable (14301). Drain crankcase. 2. Drain cooling system....
View Article1996 Nissan Altima GLE TIMING CHAIN Removal
download 1. Release fuel pressure. See FUEL PRESSURE RELEASE . Drain coolant from radiator and cylinder block. Drain engine oil. Disconnect all necessary coolant hoses, electrical connectors, vacuum...
View Article2007–2009 Toyota Tacoma Decreased Air Volume from HVAC Vents
download Some customers may experience decreased air volume from the HVAC vents when the temperature is set to maximum heat. Use the following repair procedure to address the customer concerns....
View Article1997 Ford F-250/350/Super Duty Axle Shaft, Hub, Oil Seal and Outer Wheel...
download Removal NOTE: If, for any reason, the rear hub (1109) is removed from the spindle, the old hub seal must be removed and a new hub seal installed. 1. Set the parking brake and loosen the eight...
View Article1994 Ford Mustang A/C Evaporator Housing Removal and Installation
download 1. Disconnect battery ground cable (14301) . 2. Remove two console armrest mounting access covers (047A62) at rear of console panel (045A36) (snaps out) to gain access to armrest retaining...
View Article2000- 2005 Lincoln Aviator, Ford Explorer, Exp Sport, Exp Sport-Trac, Mercury...
download Removal & Installation WARNING Do not loosen the axle wheel hub retainer until the wheel and tire are removed from the vehicle. Wheel bearing damage will occur if the wheel bearing is...
View Article1997 Cadillac Catera Drive Axles, Bearings and Joints: Rear Suspension...
download 1. Raise and support the vehicle. 2. Remove the tire and wheel assembly. 3. Use the J 42066 and use a 1/2 inch breaker bar to counter hold the rear wheel hub. Important: DO NOT allow the drive...
View Article2001 Toyota Sienna CE Trunk / Liftgate Service and Repair DISASSEMBLY
download 1. REMOVE BACK DOOR ASSIST GRIP a. Using a screwdriver, open the covers. HINT: Tape the screwdriver tip before use. b. Remove the 2 screws and assist grip. 2. REMOVE BACK DOOR PULL STRAP a....
View Article1993 Mitsubishi Montero TRANSFER CASE DISASSEMBLY
download Disassembly (Ram-50) 1) Remove both 4WD indicator switches and steel balls. Remove speedometer gear assembly. Remove output shaft cover, gasket, wave spring and spacer. See Fig. 3. Remove rear...
View Article
